Waterproofing System | HFA Respect


Entech HFA Respect system is a hot applied bitumen-rubber based water insulation system. It is a homogeneous mixture of refined asphalts, mineral fillers and synthetic rubber materials. It is applied by melting at a suitable temperature (195 degrees) in special melting boilers with ELECTRIC MELTER 500 mixer produced by Entech, pouring and pulling with a squeegee.


Please click on "Offer Request" button below to send your offer and detailed information request to the company for the Waterproofing System | HFA Respect product.


- Toured - non-toured terraces
- Garden terraces
- Underground - above ground parking lot flooring
- Open-cover tunnel flooring
- Viaduct flooring
*Since it is not a UV resistant product, it should be covered appropriately after application.

• It creates a hard, flexible and self-renewing water insulation layer.
• It creates a 100% solid monolithic layer and does not contain volatile substances etc.
• Its usage cost is lower than water-based systems. For example, an application of 4.5 kg/m2 leaves a 3.75 mm net film in Entech HFA Respect System. In water-based systems, an application of approximately 6.0-6.5 kg/m2 is required to obtain this amount of dry film.
• It is poured at high temperatures, fills all gaps, adheres completely and does not allow water to flow in the event of a possible puncture.
• Since no curing is required after application, it is not affected by environmental effects, and it is sufficient for the hot application to cool down to be put into use.
• It adheres very strongly to metal-concrete surfaces and forms a monolithic waterproofing layer
• It is acid and alkali resistant.
• It has high crack bridging properties.
• It is a high viscosity material.
• It is suitable for cold climate applications. (-18 C)